Photo Gallery

Projects LARGE and small. The photos below show the diverse nature of past projects. Our technical staff loves a challenge, can we help you?


CPR is a 23,400 Sq. Ft. facility with 3 high bay shop areas and is located on over 2 acres of land.	Shop Machining Bay (4) Lathes; VTL; VBM; HBM; Bridgeport Mill; Radial Arm Drill; Overhead Lifting to 10T

Shop Disassembly / Assembly / Lay-out Bay Overhead lifting to 15 Ton; Hydraulic Vertical Stacking Table; Balance Stand; Blast Cleaning Booth in rear; High-bay overhead doors with docking or drive-in loading/off-loading capabilities.	Computerized Schenk Balance Stand Capacity to 7500 pounds; 30” Dia. And 168” in length

Lifting capabilities to handle from the smallest to the largest of equipment. Up to 25 Ton	Special Fixture for Final Inspection: Lift / End Float Checks on Boiler Feed Pumps

Vertical Hydraulic Stacking Table in Assembly Area	Foster Wheeler 60” Impeller 316 Stainless Steel 3 week turn-around, incl. making a pattern; 2150 pounds

I-R 28APKC Impeller (1 week turn around)	Wx 8WC137 Parts

I-R 28APKC Impeller (1 week turn around)	I-R HMTA at Disassembly

Little Pumps! Sier-Bath Gearex Pump Cleaned and laid out for inspection	Delaval 42”x36” CWP at final Assembly (stands over 10’ high)